Publication date: June, 2015
Revision A1
About This Manual
Copyright
Copyright © 2015 Manufacture Technology Corp. All rights reserved.
The products and programs described in this User’s Manual are licensed products of
Manufacture Technology, This User’s Manual contains proprietary information
protected by copyright, and this User’s Manual and all accompanying hardware,
software and documentation are copyrighted. No parts of this User’s manual may be
copied, photocopied, reproduced, translated or reduced to any electronic medium or
machine-readable from by any means by electronic or mechanical. Including
photocopying, recording, or information storage and retrieval systems, for any purpose
other than the purchaser’s personal use, and without the prior express written
permission of Manufacture Technology.
Purpose
This manual gives specific information on how to operate and use the management
functions of the GEP-2651
Audience
The Manual is intended for use by network administrators who are responsible for
operating and maintaining network equipment; consequently, it assumes a basic
working knowledge of general switch functions, the Internet Protocol (IP), and Simple
Network Management Protocol (SNMP).
CONVENTIONS
The following conventions are used throughout this manual to show information.
WARRANTY
See the Customer Support/ Warranty booklet included with the product. A copy of the
specific warranty terms applicable to your Manufacture products and replacement
parts can be obtained from your Manufacture Sales and Service Office authorized
dealer.
Disclaimer
Manufacture Technology does not warrant that the hardware will work properly in all
environments and applications, and marks no warranty and representation, either
implied or expressed, with respect to the quality, performance, merchantability, or
fitness for a particular purpose. Manufacture disclaims liability for any inaccuracies or
omissions that may have occurred. Information in this User’s Manual is subject to
change without notice and does not represent a commitment on the part of
Manufacture. Manufacture assumes no responsibility for any inaccuracies that may be
contained in this User’s Manual. Manufacture makes no commitment to update or
keep current the information in this User’s Manual, and reserves the righter to make
improvements to this User’s Manual and /or to the products described in this User’s
Manual, at any time without notice.
FCC Warning
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference when the equipment is
operated in a commercial environment. This equipment generates, uses, and can
radiate radio frequency energy and, if not installed and used in accordance with the
Instruction manual, may cause harmful interference to radio communications.
FCC Caution
To assure continued compliance (example-use only shielded interface cables when
connection to computer or peripheral devices). Any changes or modifications not
expressly approved by the party responsible for compliance could void the user’s
authority to operate the equipment. This device complies with Part 15 of the FCC
Rules. Operation is subject to the Following two conditions: (1) This device may not
To Next Page
Loading...
