Publication date: June, 2015
Revision A1
5-4.3 Download
This section describes to export the Switch Configuration for maintenance needs. Any current
configuration files will be exported as text format.
It is possible to download a file from the web browser to all the files on the switch, except
default-config, which is read-only.
Select the file to download, select the destination file on the target, then click .
If the destination is running-config, the file will be applied to the switch configuration. This
can be done in two ways:
Replace mode: The current configuration is fully replaced with the configuration in the
downloaded file.
Merge mode: The downloaded file is merged into running-config.
If the file system is full (i.e. contains the three system files mentioned above plus two other
files), it is not possible to create new files, but an existing file must be overwritten or another
deleted first.
Web Interface
To download configuration in the web interface:
1. Chick Browser to select Maintenance/Configuration in you device.
2. Click Download Select.
Figure 5-4.3: Configuration Download
To Next Page
