Publication date: June, 2015
Revision A1
Auto-refresh :
To evoke the auto-refresh icon then the device will refresh the information automatically.
Upper right icon (Refresh):
You can click them for refresh the Protocol Group Mapping information by manual.
2-15.3 IP Subnet-based VLAN
The IP subnet-based VLAN entries can be configured here. This page allows for adding,
updating and deleting IP subnet-based VLAN entries and assigning the entries to different
ports. This page shows only static entries.
Web Interface
To Display IP subnet-based VLAN Membership to configured in the web interface:
1. Click VCL, Group Name VLAN configuration and add new entry.
2. Specify the VCE ID, IP Address, Mask Length, VLAN ID and select Port Members.
3. Click Apply.
Figure 2-15.3: IP Subnet-based VLAN Membership Configuration
Parameter description:
Delete
To delete a IP subnet-based VLAN entry, check this box and press save. The entry will be
deleted on the selected switch in the stack.
VCE ID
Indicates the index of the entry. It is user configurable. It's value ranges from 0-128. If a VCE
ID is 0, application will auto-generate the VCE ID for that entry. Deletion and lookup of IP
subnet-based VLAN are based on VCE ID.
IP Address
Indicates the IP address.
Mask Length
Indicates the network mask length.
VLAN ID
Indicates the VLAN ID. VLAN ID can be changed for the existing entries.
Port Members
A row of check boxes for each port is displayed for each IP subnet-based VLAN entry. To
include a port in a IP subnet-based VLAN, check the box. To remove or exclude the port
To Next Page
