"CLIF" - Command Line Interface Help
Z-Max Advanced Programming & Systems Design Guide rac00-sdg
Revision A:11/2005 Page 103
"CLIF" - Command Line Interface
All Z-Max panels have a command line interface which can be used for diagnostic and
control purposes. The command line interface can be accessed via USB, the data
modem, or Ethernet.
The terminal interface can be accessed via any terminal program. The parameters for
connecting are as follows:
Figure 10: Terminal Connection Parameters
Help
Once you’re connected to your panel, you may use the "help" command to list out all
of the available commands and their syntax.
Parameter Value
Baud Rare 115,200kbps
Packet Size 8 Bits
Parity None
Stop Bit 1
Flow Control Hardware
To Next Page
Loading...
