Page 18
After the two short beeps are heard (step 3 above), any of the following commands
can be entered, followed by the pound (#) key:
• 0 - Turn group off at normal priority, all other actions can override
• 1 - Turn group on at normal priority, all other actions can override
• 2 - Turn group on at high priority, most other actions can not override
• 3 - Turn group On at normal priority only for a defined period of time (defined by
your administrator)
• 7 - Relinquish control of the group to all other actions and controlling sources
• 8 - Turn group off at high priority, most other actions can not override
• 9 - Turns group Blink Warn Off at normal priority
• 10 - Cancels blink warn for this group at normal priority
Administrator Mode
In administrator mode, you have complete control over all "Groups" of relays as
defined by the panel administrator. You know that you’re in administrator mode
because after entering your password, you hear 1 beep instead of two.
In administrator mode, the complete process is as follows:
Step 1: Call your relay panel, wait for it to answer, and wait for (3) short beeps
Step 2: Enter your password followed by the pound (#) key
Step 3: Hear (1) short beep indicating admin mode
Step 4: Enter one of the following commands, followed by the pound (#) key:
• 0 - Turn group off at normal priority, all other actions can override
• 1 - Turn group on at normal priority, all other actions can override
• 2 - Turn group on at high priority, most other actions can not override
• 3 - Turn group On at normal priority only for a defined period of time
(defined by your administrator)
• 7 - Relinquish control of the group to all other actions and controlling
sources
• 8 - Turn group off at high priority, most other actions can not override
• 9 - Turns group Blink Warn Off at normal priority
• 10 - Cancels blink warn for this group at normal priority
Step 5: Hear (2) short beeps indicating that the command is valid
Step 6: Enter a group number followed by the pound (#) key
Step 7: Hear (2) short beeps indicating that the command was executed
Step 8: Repeat steps 4, 5, 6, & 7 or hand up to terminate the call.
To Next Page
Loading...
