Diagnostic aids 3-3
7526
HARDWARE TESTS
Panel Test See “Panel Test” on page 3-12.
Button Test See “Button Test” on page 3-13.
DRAM Test See “DRAM Test” on page 3-13.
Serial 1 Wrap (if a serial port is
available in the PCI slot 1)
See “Serial 1 Wrap” on page 3-13.
USB HS Test Mode See “USB HS Test Mode” on page 3-14.
DUPLEX TESTS (if installed)
Quick Test See “Quick Test (duplex)” on page 3-15.
Print Test See “Print Test (duplex)” on page 3-16.
Top Margin See “Top Margin (duplex)” on page 3-17.
Left Margin See “Left Margin (duplex)” on page 3-17.
Skew See “Skew (duplex)” on page 3-17.
Sensor Tests
Static Sensors See “Sensor Tests” on page 3-18.
Dynamic Sensors
Other Sensors
PRINTHEAD TESTS
Mirror Motor Test See “Mirror Motor Test” on page 3-19.
Servo Laser Test See “Servo Laser Test” on page 3-19.
DEVICE TESTS (if hard disk or flash is installed)
Quick Disk Test See “Quick Disk Test” on page 3-20.
Disk Test/Clean See “Disk Test/Clean” on page 3-20.
Flash Test See “Flash Test” on page 3-21.
PRINTER SETUP
Defaults See “Defaults” on page 3-21.
Prt Color Page Count See “Page Counts” on page 3-21.
Prt Mono Page Count
Perm Page Count
Serial Number See “Serial Number” on page 3-22.
Model Name See “Model Name” on page 3-22.
Engine Setting 1 through 4 See “Engine Setting 1 through 4” on page 3-22.
Configuration ID See “Configuration ID” on page 3-22.
Reset Color Cal See “Reset color calibration (Reset Color Cal)” on page 3-23.
Par 1 Strobe Adj See “Parallel 1 strobe adjustment (Par 1 Strobe Adj)” on
page 3-23.
Motor Calibration See “Motor Calibration” on page 3-23.
EP SETUP
EP Defaults See “EP Defaults” on page 3-23.
Fuser Temp See “Fuser temperature (Fuser Temp)” on page 3-24.
DC Charge Adjust See “DC Charge Adjust, Dev Bias Adj, Transfer Adjust” on
page 3-24.
Dev Bias Adj
Transfer Adjust
To Next Page
Loading...
