Diagnostic information 2-23
7526
200.22 Pick (tray 1) motor stalled.
Possible causes:
• Faulty cable/connector
• Faulty pick motor
• Faulty system board
• Check for anything in the paper path that might
cause the paper to jam.
• If clearing a paper jam does not fix the problem,
go to “140.xx, 920.02—Autocomp (tray 1)
motor error service check” on page 2-51.
200.25 Input sensor is made when tray 1 is
installed.
Possible causes:
• Improper placement of paper in
tray 1
• Damaged input sensor flag or
input sensor
• Faulty system board
• Fan media, and stack flat in the tray or
multipurpose feeder.
• Properly set media restraints in the paper tray.
• If clearing a paper jam does not fix the problem,
go to “920.06—Input sensor service check”
on page 2-114.
200.30 Paper hit input sensor too soon.
Possible causes:
• Incorrect paper loading
• Damaged input sensor flag or
input sensor
• Faulty system board
• Fan the media, and then stack flat in the tray.
• Check for anything in the paper path that might
cause the paper to jam.
• The input sensor may not be functioning
properly. Go to “920.06—Input sensor service
check” on page 2-114.
201.02 Bubble sensor active when printing
started.
Possible causes:
• Paper jam leaving page over
sensor
• Damaged bubble sensor
• Damaged fuser autoconnect
• Faulty fuser DC cable connection
• Faulty fuser
• Faulty system board
• Clear away anything in the paper path that might
cause the paper to jam.
• Ensure proper media is set for the type of paper
used.
• Fan media, and stack flat in the tray.
• Properly set media restraints in the paper tray.
• If clearing a paper jam does not fix the problem,
go to “Bubble sensor service check.” on page...
201.06 Paper is jammed between the input
sensor and the exit sensor.
Possible causes:
• Damaged paper exit sensor or
paper exit sensor flag
• Transport belt module failure
• Aligner failure
• Damaged fuser autoconnect
• Faulty fuser DC cable connection
• Faulty fuser
• Faulty system board
• Check for anything in the paper path that might
cause the paper to jam.
• If the problem persists, go to “201.06, 201.08,
201.31—Paper Jam error service check” on
page 2-69.
201.07 Exit sensor is made early.
Possible causes:
• Damaged paper exit sensor or
paper exit sensor flag
• Damaged fuser autoconnect
• Faulty fuser DC cable connection
• Faulty fuser
• Faulty system board
• Faulty input sensor flag
• Check for anything in the paper path that might
cause the paper to jam.
• The fuser exit sensor may not be functioning
properly. Go to “920.08—Exit sensor service
check” on page 2-116.
• Check the input sensor flag.
Error code Description Action
To Next Page
Loading...
