Lexmark XM3150 - Page 74

Error code Description Action
200.11 Printhead motor fell out of lock after page reaches
the input sensor.
Go to
“Sensor (input) image jam service check”
on page 77.
Mirror motor got locked, and then lost it again
before the initial lock timeout.
Go to
“Laser scanning unit (LSU) service check”
on page 134.
200.12 Printhead was not ready for media. Go to
“Sensor (input) image jam service check”
on page 77.
200.13 Media at input sensor is not the next media to be
imaged.
Go to
“Sensor (input) image jam service check”
on page 77.
200.14 Media reached the input sensor before EP was
ready.
Go to
“Sensor (input) image jam service check”
on page 77.
200.15 Image data did not start on time. Go to
“Sensor (input) image jam service check”
on page 77.
200.16 Fuser motor stalled. Go to
“Main drive motor control jam service
check” on page 78.
200.19 Page that was successfully picked from option tray
never reached the input sensor.
Go to
“Sensor (input) early/late arriving service
check” on page 76.
200.21 No response from paper port driver while waiting
for the source to deactivate the Input Source
Ready
flag
to indicate it has initiated picking.
Go to
“Sensor (input) early/late arriving service
check” on page 76.
200.23 Laser servo never started due to potential conflict
with the transfer servo.
Go to
“Sensor (input) image jam service check”
on page 77.
200.24 Measured gap at input sensor too small to meet
video delivery requirements. (Not enough time
since prior image
finished
to start new image).
Go to
“Sensor (input) image jam service check”
on page 77.
200.29 Printhead drive control out of range due to an
external event beyond what the control is
designed to handle.
Go to
“Sensor (input) image jam service check”
on page 77.
200.30 Invalid printhead NVRAM. Go to
“Sensor (input) image jam service check”
on page 77.
200.31 Paper, in the middle of a job, at input sensor before
interrupt occurred.
Go to
“Sensor (input) early/late arriving service
check” on page 76.
200.32 Detected cover switch bounce. Go to
“Sensor (input) early/late arriving service
check” on page 76.
Printhead lost HSYNCs due to a glitch with the
laser safety interlock, for example, bouncy cover
switch.
Go to
“Laser scanning unit (LSU) service check”
on page 134.
200.33 Input sensor covered too quickly. Go to
“Sensor (input) early/late arriving service
check” on page 76.
200.38 Interpage servo gap smaller than expected for
galvo oset target evaluation.
Go to
“Sensor (input) early/late arriving service
check” on page 76.
200.42 Rogue sheet at ACM sensor while flushing the
paper path prior to declaring Tray 1 source empty.
Go to
“Sensor (input) early/late arriving service
check” on page 76.
7016
Diagnostic information
74