Lexmark XM3150 - Page 75

Error code Description Action
200.44 Page from Tray 1 did not reach the input sensor (or
the manual feed sensor, if present) after multiple
pick attempts. Page did make it out of the tray at
least as far as the ACM sensor.
Go to
“Sensor (input) early/late arriving service
check” on page 76.
200.45 During warm up flush, sheet detected too long
over input sensor.
Go to
“Sensor (input) early/late arriving service
check” on page 76.
Sensor (input) static jam service check
Action Yes No
Step 1
Check the input sensor area for jammed media fragments.
Is the paper path free of partially fed or jammed media?
Go to step 2. Clear the paper path
of any media
fragments.
Step 2
Check the jam access cover if it is blocking the input sensor.
Is it blocking the input sensor?
Replace the jam
access cover. See
“Jam access cover
removal” on
page 315.
Go to step 3.
Step 3
Check the input sensor cable for proper connection.
Is it properly connected?
Go to step 4. Reseat the cable.
Step 4
POR into the Diagnostics menu and perform a sensor test:
Diagnostics Menu > Base Sensor Test > Input.
Does the sensor state on the control panel display change when
it is toggled?
Go to step 5. Replace the input
sensor. See
“Duplex
sensor and input
sensor removal” on
page 325.
Step 5
Does the error remain?
Contact the next
level of support.
The problem is
solved.
7016
Diagnostic information
75