Beta Draft Confidential
Installing and Removing Modules
Installing or Replacing Power Supplies
6-324/5/03 CBX 500 Multiservice WAN Switch Hardware Installation Guide
f. Reinstall the locking nut onto each post, then use a 7/16-in. wrench or socket
to tighten the nut.
g. Reinstall the protective cover by tightening its two screws.
h. Plug the power cord into a DC power source. To ensure continuous power in
the event of a power source failure, you should plug each power cord into a
different DC power source, if possible.
6. Toggle the power switch for the power supply module to the ON position.
7. Reinstall the front bezel by aligning the four posts on each side of the cover with
the holes on the fan assembly cover and power supplies. Then push on both sides
of the cover with the palms of your hands to snap the cover back into place.
To Next Page
Loading...
Need help?
General
