CBX 500 Multiservice WAN Switch Hardware Installation Guide xxi
Beta Draft Confidential
About This Guide
The CBX 500 Hardware Installation Guide describes how to install and set up the
CBX 500
®
switch hardware, replace hardware modules, and interpret LED status
indicators. This guide also provides basic troubleshooting solutions for potential
hardware-related problems.
This guide is intended for network operations staff, systems integrators, and other
qualified service personnel responsible for installing the CBX 500 switch.
What You Need to Know
The procedures in this guide require you to understand and follow the safety practices
at your site, as well as those identified in this guide. The procedures also require you
to understand the temperature, humidity, and electrical requirements for the
installation site, which are described in Chapter 2, “Specifications and Safety
Warnings.”
You must also understand the switch’s position in the overall network design before
you can connect the switch to a network. You should work closely with the Network
Management Station (NMS) operator and other systems integration personnel to
ensure a functional installation.
Be sure to read the software release notice (SRN) that accompanies this product.
The SRN contains the most current product information and requirements.
To Next Page
Loading...
Need help?
General
