Regulatory Information
FCC and Telephone Company Procedures and Requirements
Beta Draft Confidential
CBX 500 Multiservice WAN Switch Hardware Installation Guide 4/5/03C-7
FCC and Telephone Company Procedures and
Requirements
To connect this system to the network, you must provide the local operating company
with the registration number of this equipment, and you must order the proper
connections.
To order the proper service, provide the telephone company with the following
information:
• Quantities and USOC numbers of the required jacks
• Sequence in which the trunks are to be connected
• Facility interface codes, by position
• Ringer equivalence number or service code, as applicable, by position
Radio Frequency Interference
The CBX 500 switch is designed for Class A use only. Do not attempt to use this
equipment in a domestic environment, which requires Class B distinction. These
switches cause interference with domestic products.
This equipment produces electromagnetic energy at radio frequencies and, if not
installed and operated in accordance with the manufacturer’s instructions as contained
in this document, could cause interference to radio communications and/or interfere
with the operation of other RF devices. The equipment has been tested and found to
comply with the limits for a Class A Computing Device pursuant to Subpart B of Part
15 of the FCC Rules, which are designed to provide reasonable protection against
such interference when the equipment is operated in a commercial environment.
Operation of the equipment in a residential area may cause interference. Should this
occur, the user may be required to discontinue operation of the equipment, or take
other such measures as may be adequate to rectify the condition at the user’s expense.
!
Caution - In accordance with FCC Part 15 Subpart B requirements, changes or
modifications made to this equipment not expressly approved by Lucent
Technologies could void user’s authority to operate this equipment.
To Next Page
Loading...
Need help?
General
