Lucent Technologies DDM-2000 OC-3 User Manual

SET-STATE-OC1 3of1Page SET-STATE-OC1
NAME
StateLineOC-1Setset-state-oc1:
FORMATINPUT
set-state-oc1: Address :ps= PrimaryState ;
DESCRIPTION
usediscommandThislines.OC-1moreoroneofstatethesetscommandThis
line.specifiedafromfailuressignalofmonitoringtheoffandonturnto
are:parametersinputThe
Address line(s).OC-1theidentifiesAddress
OLIU):27-type(forAddressesLineOC-1Valid
main-{1,2}-{1,2},main-all,all,
fn-{a,b,c}-{1,2}-{1,2}fn-all,
OLIU):26G2-U(forAddressesLineOC-1Valid
fn-{a,b,c}-{1,2}-1fn-all,
ps followingtheofonehavemaywhichstatelinetheisPrimaryState
values:
nmon alarmreportnotDomonitored.nottostatelinetheSet
lineandSectionline.theforconditionsstatusor
stoppedbewillcollectiondatamonitoringperformance
ifin-servicetostatelinethechangenotDostate.thisin
thisinremainwilllineThedetected.issignalgooda
thiswithagainchangedisstatetheuntilstate
command.
NOTE:
datatheNMON,tosetisstatelinetheWhen
disabled.bewill(DCC)channelcommunication
is goodformonitoredbetostatelinetheSetIn-service.
statusalarm,ofReportingline.specifiedtheatsignal
state.normalinisdataPMONandconditions,
NOTE:
theUse set-fecom theenabletocommand
beenhavemight(thatDCCcorresponding
NMON).ofstatepreviousaofbecausedisbaled
OC-3DDM-2000 2000February2Issue 11-437

Lucent Technologies DDM-2000 OC-3 Specifications

General

Brand	Lucent Technologies
Model	DDM-2000 OC-3
Category	Multiplexer
Language	English