SET-SECU 7of1Page SET-SECU
NAME
SecuritySetset-secu:
FORMATINPUT
set-secu:
Address
[:[sec=
Security
][,to=
Timeout
]};
set-secu:
Address
[:[porttype=
Porttype
][,baudrate=
Baudrate
]
[,echo=
echo
][,sec=
Security
][,to=
Timeout
]];
later)and15.0Release(OC3
DESCRIPTION
CITeachonsecuritysystem(NE)elementnetworkconfigurescommandThis
alsowillcommandthis15.0,ReleaseOC-3withStartinginterface.DCCand
CITrear/frontthefrommessagesTL1transmitand/orreceivetousertheallow
tointerfacesynchronousX.25thechangetoallowedbealsowilluserTheports.
asynchronous
areloginsdefaultthreeThe LUC01, LUC02 and, LUC03 upper-case(all
ispassworddefaultTheletters). DDM-2000 changeshouldusersPrivileged.
state.lockoutatosecuritysettingorsecurityenablingbeforedefaultsthese
NOTE:
only.usersprivilegedtoavailableiscommandThis
are:parametersinputThe
address ports.DCCand/orCITmoreoroneofaddresstheisAddress
address.defaultnoisThere
Addresses:Valid cit-{1,2,all}dcc-all,
interfaces):(OC-1AddressesValid dcc-all
is:interfaceX.25forAddressValid x25
later)and15.0Release(in
porttype AddressprovisionedthewhetherSpecifies cit-1 -port(DCE
oraccess)front cit-2 forusedisaccess)rear-port(DTE
CIT
or
TL1
isAddressofvaluetheIfapplication. cit-2orcit-1 ,
values:possibletwohavecanparameterthis cit or tl1.
isvalueDefault cit.
isAddressofvaluetheIf x25 twohavecanparameterthis,
values:possible synch orTL1),fortypeport(default asynch.
isvalueDefault synch.
TL1runtoprovisionedbecanCIT-2)or(CIT-1portCIToneOnly
typeportCIT-2’sTL1,asprovisionedistypeportCIT-1’sif(e.g,
aotherwisevice-versa),andTL1,runtoprovisionedbecannot
later).(defineddisplayedismessagedenial
OC-3DDM-2000
2000February2Issue 11-427
To Next Page
Loading...
Need help?
General
