Lucent Technologies DDM-2000 OC-3 User Manual

SET-T1 6of1Page SET-T1
NAME
CharacteristicsT1Setset-t1:
FORMATINPUT
set-t1: address [:lc= LineCode ][,alm= AlarmLevel ][,fth= FailureThreshold ]
[,dlc= DLCBPVtoLOS ][,ais= AlarmIndicationSignal ][,pmmd= PMMode ]
[,fmt= Format ];
set-t1: address [:pmmd= PMMode ][,fmt= Format ];
pack)circuitTMUXBBG20later,and13.0ReleaseOC-3(For
set-t1: address [:alm= AlarmLevel ][,pmmd= PMMode ];
only)packcircuitLANIMAlater,and15.0ReleaseOC-3(For
DESCRIPTION
!
CAUTION:
service.affectmaycommandthisofExecution
Theseports.DS1moreoroneofparametersthesetscommandThis
AISandthresholds,failurecoding,linelevels,alarmincludecharacteristics
conditions.
andModePMthesetsalsocommandthislater,and13.0ReleaseOC-3In
TMUXthewithassociatedsignalsDS1internaltheforparametersFormat
packs.circuit(BBG20)
thispacks,circuitLANIMAtheusingwhen15.0,ReleaseOC-3withStarting
isFormat(PMFormat.PMandMode,PMLevels,Alarmthesetscommand
tosetalways esf).
NOTE:
theallwithprovisionedautomaticallyispackcircuitprotectionDS1The
theforexceptprotects,itpackservicetheasoptionsuser-settablesame
CIT).theviaprovisionednotis(whichvalue(LBO)buildoutline
are:parametersinputThe
Address Oneprovisioned.betoport(s)DS1theofaddresstheisAddress
specified.bemaymoreorport
Addresses:Valid {a,b,c}-{1-7,all}-{1-4,all}all,
twosupports15.0)Release(OC-3packcircuit(BBF6)T1EXTThe
1numbersportonlyBBF6,aonportsaddressingWhenports.T1
Specifyingvalid.are2and all only.2and1portsselects
OC-3DDM-2000
2000February2Issue 11-465

Lucent Technologies DDM-2000 OC-3 Specifications

General

Brand	Lucent Technologies
Model	DDM-2000 OC-3
Category	Multiplexer
Language	English