Issue 3 June 2001 8-1
8
Administration and Provisioning 8
Overview 8
This section describes the administration and provisioning features of the
DDM-2000 OC-3 Multiplexer. The following topics are described in addition to the
administration and provisioning features:
■ Multiplexing and mapping
■ Cross-connection provisioning for linear and ring networks
■ Listing of provisionable parameters with their ranges and default values.
Administration 8
Version Recognition 8
The DDM-2000 OC-3 Multiplexer provides automatic version recognition of all
hardware, firmware, and software installed in the system. Each circuit pack
Common Language
*
code, equipment catalog item (ECI) code, apparatus code
and series number, and serial number is stored on the circuit pack and is
accessible by the system controller (SYSCTL) via the craft interface terminal
(CIT). Circuit packs with socketed devices also report those devices and program
identification (PID) codes. The SYSCTL also reports the software version for the
system. Refer to the rtrv-eqpt command in Section 11, "Commands and
Reports.”
* Common Language is a registered trademark, and CLEI, CLLI, CLCI, and CLFI are
trademarks of Bell Communications Research, Inc.
To Next Page
Loading...