363-206-285 System Turnup: NTP-041
Issue 2, February 2000 Page 6 of 8
DDM-2000 OC-3 MULTIPLEXER
DO ITEMS BELOW IN ORDER LISTED . . . . .FOR DETAILS, GO TO
15.
NOTE:
DDM-2000 shelves that are part of a subnetwork being
partitioned into multiple areas require that the NSAPAREA
field and level 2 IS-IS routing parameters of the
ent-ulsdcc-l3: command be set. See Section 11,
Commands and Reports in 363-206-285,
DDM-2000 OC-3
Multiplexer, TARP Release 13 and Later, User/Service
Manual—Volume I
and 363-206-295,
DDM-2000 OC-12
Multiplexer, TARP Release 7, User/Service Manual—Volume
I
, for an explanation of the command parameters. FT-2000
shelves that are part of a subnetwork being partitioned into
multiple areas require that the L3 Area Address and Level 2
IS parameters of the CONFIGURATION-Set-ULSDCC-L3
command be set. See 365-575-103,
FT-2000 OC-48
Lightwave System, Release 8.1 Through 9.1, User/Service
Manual
, for an explanation of the command parameters.
See 824-102-144,
Lucent Technologies 2000 Product
Family, Operations Interworking Guide For TARP Releases
,
for an explanation of the engineering rules for subnetwork
partitioning.
At the DDM-2000 shelf, use the ent-ulsdcc-l3 command to
designate the NSAPAREA field and level 2 IS-IS routing, as
required.
At the FT-2000 shelf, use the
CONFIGURATION-Set-ULSDCC-L3 command to designate the
L3 Area address and Level 2 IS parameters, as required.
DLP-51516. Perform end-to-end OC-3 line test at DRI nodes.
17. The system is now ready for initial service to be established.
Initial DS1 Service [System Turnup: NTP-004]
Initial DS3 Service [System Turnup: NTP-005]
Initial EC-1 Service [System Turnup: NTP-034]
Initial HDSL Service [System Turnup: NTP-003]
Initial LAN Service [System Turnup: NTP-028]
Initial T1 Service [System Turnup: NTP-033]
DLP-515
NTP-005
NTP-034
NTP-028
NTP-033
To Next Page
Loading...
Need help?
General
