363-206-285
Page 4 of 12 Issue 3, June 2001
DDM-2000 OC-3 MULTIPLEXER
7. When performing tests or procedures using a CIT and system commands, you
should refer to the “Commands and Reports” section of this manual for a description
of the command, its parameters, and the output messages associated with the
command.
8. If the procedure refers to software releases as TARP Release 13 or later ring
releases, it refers to all ring software TARP releases with a numerical value of 13 or
higher.
9. If you need assistance in clearing a trouble after completing all the applicable
trouble-clearing procedures in this section, contact your local or regional
maintenance assistance group. The telephone number for the Lucent Technologies
Regional Technical Assistance Center (RTAC) is 1-800-225-RTAC.
Circuit packs being returned for repair should be sent to the following address:
Lucent Technologies
Returned Goods Dept.
Dept. JC0221310
1600 Osgood Street
North Andover, Massachusetts 01845
Telephone: 1-508-960-5179
FAX: 1-508-960-1705
Screen Display and Panel Stamping Fonts
The procedures in this manual use a monospace font to identify actual text on a screen or
a response displayed from the system. A bold font identifies panel stamping such as alarm
names or circuit pack names. Also, the bold font is used throughout this manual for
emphasis.
DDM-2000 OC-3 Installation
363-206-204,
DDM-2000 OC-3 Multiplexer Installation Manual
, is available for customers
planning to install the equipment themselves. To acquire this manual, refer to “How to
Order Documents” in the About This Document tab.
Lucent Technologies recommends that ONLY designated Lucent Technologies cables be
used with DDM-2000. Failure to use these cables will void the product warranty.
To Next Page
Loading...
Need help?
General
