Lucent Technologies DDM-2000 OC-3 User Manual

SET-STATE-T1 2of1Page SET-STATE-T1
NAME
StatePortT1Setset-state-t1:
FORMATINPUT
set-state-t1: Address :ps= PrimaryState ;
DESCRIPTION
onturntousediscommandThisports.DS1ofstatethesetscommandThis
port.specifiedafromfailuressignaltoduealarmtheoffand
NOTE:
TMUXthewithinDS1s"internal"thetoapplicablenotiscommandThis
later.and13.0ReleaseOC-3inavailableisthatpackcircuit(BBG20)
existsthereifonlysetbemaystateportDS1packs,circuitLANIMAusingWhen
theatdeniedbewillrequesttheotherwiseDS1;thatoncross-connectVT1.5a
level.promptuser
are:parametersinputThe
Address port(s).DS1theidentifiesAddress
Addresses:Valid {a,b,c}-{1-7,all}-{1-4,all}all,
twosupports15.0)Release(OC-3packcircuit(BBF6)T1EXTThe
1numbersportonlyBBF6,aonportsaddressingWhenports.T1
Specifyingvalid.are2and all only.2and1portsselects
ps followingtheofonehavemaywhichstateporttheisPrimaryState
values:
auto theatsignalgoodformonitoredbetostateSet
port.specified
nmon monitored).(notalarmed""nottostateSet
NOTE:
theinisportaIf nmon thetoreturnedbemustitstate, auto (usingstate
becanportthatwithassociatedpackscircuitanybeforecommand)this
thebylistequipmentthefromremoved upd command.
isstateprimaryinterface’sLANthepack,circuitLANIMAtheusingWhen
pack.thatonprovisionedisstateprimaryDS1’sfirstthewhensetautomatically
11-446 2000February2Issue OC-3DDM-2000

Lucent Technologies DDM-2000 OC-3 Specifications

General

Brand	Lucent Technologies
Model	DDM-2000 OC-3
Category	Multiplexer
Language	English