Lucent Technologies DDM-2000 OC-3 User Manual

NTP-004: Acceptance 363-206-285
Page4of6 Issue3,June2001
DDM-2000 OC-3 MULTIPLEXER
DO ITEMS BELOW IN ORDER LISTED. . . . . FOR DETAILS, GO TO
6.
NOTE:
The rtrv-map-network and rtrv-map-neighbor
commandsmaybeusedtoretrieveamapofthenetwork,
including the systems in the network and how they are
connected.
DLP-514Ensure all DDM-2000 OC-3 shelves (OLIUs) in the network have
been properly connected to the optical facility. Verify the integrity
of each optical span.
7.
NOTE:
If Kbyte/Sbyte (sync messaging) is enabled for the at any
node in a system, it must be enabled at all nodes of the
system.
NOTE:
The rtrv-oc3: or rtrv-oc12: command retrieves the
OC-3 Line Provisioning Report or OC-12 Line
Provisioning Report. This report displays the
provisioned configuration of OC-3 lines. See the Commands
and Reports section of this manual for a description of the
rtrv-oc3: or rtrv-oc12: command format.
Use the rtrv-oc3: or rtrv-oc12: command to obtain the
OC-3 Line Provisioning Report or
OC-12 Line Provisioning Report and verify if Kbyte/Sbyte
is enabled or disabled. Use the set-oc3: or set-oc12
command to enable or disable the Kbyte/Sbyte parameter, as
required.
DLP-514

Lucent Technologies DDM-2000 OC-3 Specifications

General

Brand	Lucent Technologies
Model	DDM-2000 OC-3
Category	Multiplexer
Language	English