Lucent Technologies DDM-2000 OC-3 User Manual

NTP-020: System Turnup 363-206-285
Page 3 of 8 Issue 2, February 2000
DDM-2000 OC-3 MULTIPLEXER
DO ITEMS BELOW IN ORDER LISTED. . . . . FOR DETAILS, GO TO
4.
NOTE:
The rtrv-t3: command retrieves the T3 Port
Provisioning Report. This report lists information
about each DS3 port. This information includes attributes set
by the set-t3: command. See the Commands and
Reports section of this manual for a description of the
rtrv-t3: command format.
Use the rtrv-t3: command to obtain the T3 Port
Provisioning Report and verify the software option settings.
5.
NOTE:
DS1 circuit packs cannot be installed in a group that is
equipped with TMUX circuit packs.
DLP-513Verify the line build out (LBO) option jumpers are installed as
required and reinstall TMUX circuit pack(s).
6. Make the appropriate cable connection(s) to the DS3
cross-connect point(s) or equivalent connection point(s) for the
circuit being added.
7. At the DS1 terminating node(s) of the circuit being established,
determine which DS1 port(s) is to be put into service and what
options are to be selected.
8.
NOTE:
The rtrv-t1: command retrieves the T1 Port
Provisioning Report. This report lists information
about each DS1 port. This information includes attributes
set by the set-t1: command. See the Commands and
Reports section of this manual for a description of the
rtrv-t1: command format.
At each DS1 terminating node, use the rtrv-t1: command to
obtain the T1 Port Provisioning Report and verify the
hardware and software option settings.
DLP-513

Lucent Technologies DDM-2000 OC-3 Specifications

General

Brand	Lucent Technologies
Model	DDM-2000 OC-3
Category	Multiplexer
Language	English