363-206-285 System Turnup: NTP-033
Issue 2, February 2000 Page 2 of 6
DDM-2000 OC-3 MULTIPLEXER
DO ITEMS BELOW IN ORDER LISTED . . . . .FOR DETAILS, GO TO
NOTE:
If the DDM-2000 fails to respond in the indicated manner,
refer to Trouble Clearing: IXL-001.
Verify that no LEDs or alarms are activated. If any LEDs or alarms
are activated, refer to Trouble Clearing: IXL-001 and follow the
appropriate trouble-clearing procedure.
2.
NOTE:
The rtrv-eqpt: command retrieves the Equipage and
Version Report. This report lists the circuit pack type
and version information for one or more slots. See the
Commands and Reports section of this manual for a
description of the rtrv-eqpt: command format.
At each DDM-2000 OC-3 terminating end, use the rtrv-eqpt:
command to obtain the Equipage and Version Report and
verify that the proper service and protection (if required) MXRVO
circuit packs have been installed in FUNCTION UNITS group(s)
(A, B,orC) being put into service.
3. At the T1 terminating node(s) of the circuit being established,
determine which T1 port(s) is to be put into service and what
options are to be selected.
4.
NOTE:
The rtrv-t1: command retrieves the T1 Port
Provisioning Report. This report lists information
about each T1 port. This information includes attributes set
by the set-t1: command. See the Commands and
Reports section of this manual for a description of the
rtrv-t1: command format.
At each T1 terminating node, use the rtrv-t1: command to
obtain the T1 Port Provisioning Report and verify the
hardware and software option settings.
To Next Page
Loading...
Need help?
General
