363-206-285 Circuit Order: NTP-036
Issue 2, February 2000 Page 3 of 4
DDM-2000 OC-3 MULTIPLEXER
DO ITEMS BELOW IN ORDER LISTED . . . . .FOR DETAILS, GO TO
NOTE:
The following commands may be used to delete, enter, and
retrieve VT1.5 cross-connections: dlt-crs-vt1,
ent-crs-vt1,andrtrv-crs-vt1. The following
commands may be used to delete, enter, and retrieve STS-1
cross-connections: dlt-crs-sts1, ent-crs-sts1, and
rtrv-crs-sts1. See the Commands and Reports section
of this manual for a description of commands. See
Cross-Connection Provisioning in the Administration and
Provisioning section of this manual for more information on
cross-connections.
Use the dlt-crs-vt1: or dlt-crs-sts1: command to delete
the terminating node cross-connections for all service being
removed, if required.
7. Use the dlt-crs-vt1: or dlt-crs-sts1: command to delete
the pass-through cross-connections at each non-terminating node
for all service being discontinued, if required.
8. If STS1E circuit packs are at the other terminating node, remove
the service and protection STS1E circuit packs, if required.
9. Use the rtrv-state-eqpt: command to determine the port
state of the EC-1 port(s) of the circuit being established.
10.
NOTE:
If a port is in the nmon (n) state, the signal is not monitored
or alarmed. The port will not automatically go to the in
service (i) state when a signal is detected as it will in the
auto (a)state.Inthenmon state, the port must be returned
to the auto state, using the set-state-ec1: command,
to turn on monitoring of signal failures and before any circuit
packs associated with that port can be removed from the
equipment list by the upd command.
Use the set-state-ec1: command to set the port state of the
EC-1 port(s) of the circuit being established.
To Next Page
Loading...
Need help?
General
