NTP-038: Circuit Order 363-206-285
Page 3 of 6 Issue 2, February 2000
DDM-2000 OC-3 MULTIPLEXER
DO ITEMS BELOW IN ORDER LISTED. . . . . FOR DETAILS, GO TO
NOTE:
The following commands may be used to convert, delete,
enter, and retrieve cross-connections: cnvt-crs,
dlt-crs-sts, dlt-crs-vt1, ent-crs-sts1,
ent-crs-vt1, rtrv-crs-sts1, and rtrv-crs-vt1.
See the Commands and Reports section of this manual for a
description of commands. See Cross-Connection
Provisioning in the Administration and Provisioning section
of this manual for more information on cross-connection
provisioning.
Use the dlt-crs-sts1: or dlt-crs-vt1: command to delete
cross-connections associated with all DS1/DS1PM circuit packs
being removed.
7. Remove the DS1/DS1PM circuit packs from group being
converted to EC-1 service.
8. Remove the MXRVO circuit packs from group being converted to
EC-1 service.
9. Momentarily depress the UPD/INIT buttonontheSYSCTL to
update the DDM-2000 internal equipment list.
10. Verify that all alarms are off.
DLP-51311. Set the S1 switch on the STS1E circuit pack to LOW-SPEED
operating mode ("I or III" position).
12.
NOTE:
DS1/DS1PM circuit packs cannot be installed in a group
that is equipped with STS1E circuit packs.
DLP-513Set line build out (LBO) option jumpers and install STS1E circuit
packs into FUNCTION UNITS group (A, B,orC) being put into
service.
13. Use the set-ec1: command to set the characteristics of the
EC-1 port.
DLP-513
To Next Page
Loading...
Need help?
General
