NTP-049: Circuit Order 363-206-285
Page 6 of 10 Issue 2, February 2000
DDM-2000 OC-3 MULTIPLEXER
DO ITEMS BELOW IN ORDER LISTED. . . . . FOR DETAILS, GO TO
16.
NOTE:
DDM-2000 shelves that are part of a subnetwork being
partitioned into multiple areas require that the NSAPAREA
field and level 2 IS-IS routing parameters of the
ent-ulsdcc-l3: command be set. See Section 11,
Commands and Reports in 363-206-285,
DDM-2000 OC-3
Multiplexer, TARP Release 13 and Later, User/Service
Manual—Volume I
, for an explanation of the command
parameters. FT-2000 shelves that are part of a subnetwork
being partitioned into multiple areas require that the L3 Area
Address and Level 2 IS parameters of the
CONFIGURATION-Set-ULSDCC-L3 command be set. See
365-575-103,
FT-2000 OC-48 Lightwave System, Release
8.1 Through 9.1, User/Service Manual
, for an explanation of
the command parameters. See 824-102-144,
Lucent
Technologies 2000 Product Family, Operations Interworking
Guide For TARP Releases
, for an explanation of the
engineering rules for subnetwork partitioning.
At the DDM-2000 shelf, use the ent-ulsdcc-l3: command to
designate the NSAPAREA field and level 2 IS-IS routing, as
required.
At the FT-2000 shelf, use the
CONFIGURATION-Set-ULSDCC-L3 command to designate the
L3 Area address and Level 2 IS parameters, as required.
DLP-51517. Perform automatic end-to-end OC-3 line test on new OC-3 optical
extension.
DLP-515
To Next Page
Loading...
Need help?
General
