TAP-103: Trouble Clearing 363-206-285
Page 3 of 4 Issue 2, February 2000
DDM-2000 OC-3 MULTIPLEXER
14. Determine reason for locks, inhibits, etc. to be in place. See the Commands
and Reports section of this manual for a description of the switch-( )
commands and the rtrv-alm: command report descriptions. Use the
switch-( ) commands to reset switching mode or priority.
If you need assistance, notify your supervisor, your local technical support
organization, or call Lucent Technologies RTAC, per local operating
instructions.
15. STOP. YOU HAVE COMPLETED THIS PROCEDURE.
To Next Page
Loading...