EasyManuals Logo

Lucent Technologies DDM-2000 OC-3 User Manual

Lucent Technologies DDM-2000 OC-3
2536 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #1973 background imageLoading...
Page #1973 background image
TAP-107 : Trouble Clearing 363-206-285
Page 17 of 28 Issue 2, February 2000
DDM-2000 OC-3 MULTIPLEXER
inc IMA Grp Abort FE Status This status message indicates that the far-end IMA
LAN circuit pack was unable to negotiate a
mutually acceptable IMA configuration with the
near-end IMA termination. The system was unable
to transition the IMA group into the operational
state. This message has the source address of an
IMA LAN port (e.g. a-1).
Likely causes: The near-end or far-end IMA
termination may need a provisioning change to
achieve mutually acceptable configuration
parameters.
inc IMA Grp Fail Startup NE Status This status message indicates that the near-end
IMA LAN circuit pack is stuck in the IMA Group
Startup state. This could result from a near-end
IMA LAN circuit pack failure or if the far-end IMA
LAN circuit pack does not acknowledge the
near-end’s transition to the Startup State. This
message has the source address of an IMA LAN
port (e.g. a-1).
inc IMA Grp Fail Startup FE Status This status message indicates that the far-end IMA
LAN circuit pack is stuck in the IMA Group Startup
state. This could result from a far-end IMA LAN
circuit pack failure or if the near-end IMA LAN
circuit pack does not acknowledge the far-end’s
transition to the Startup State. This message has
the source address of an IMA LAN port (e.g. a-1).
inc IMA Grp Insuff Links NE Status This status message indicates that the near-end
IMA LAN circuit pack has not detected sufficient
links to transition the IMA Group into the
operational mode. The IMA LAN circuit pack
requires only one good link to transition into
operational mode. This message has the source
address of an IMA LAN port (e.g. a-1).
inc IMA Grp Insuff Links FE Status This status message indicates that the far-end IMA
LAN circuit pack has not detected sufficient links to
transition the IMA Group into the operational mode.
The IMA LAN circuit pack requires only one good
link to transition into operational mode. This
message has the source address of an IMA LAN
port (e.g. a-1).
TableB–RTRV-ALMMessageDescriptions(Continued)
Description
Alarm
Level Meaning

Table of Contents

Other manuals for Lucent Technologies DDM-2000 OC-3

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Lucent Technologies DDM-2000 OC-3 and is the answer not in the manual?

Lucent Technologies DDM-2000 OC-3 Specifications

General IconGeneral
BrandLucent Technologies
ModelDDM-2000 OC-3
CategoryMultiplexer
LanguageEnglish

Related product manuals