363-206-285 Trouble Clearing: TAP-109
Issue 2, February 2000 Page 2 of 4
DDM-2000 OC-3 MULTIPLEXER
4. Connect the CIT to the CIT connector on the near-end User Panel and log in to
the near-end system, if not already performed.
Reference: DLP-521
5.
NOTE:
The rtrv-alm: command can be used to display a report of active
alarm and status conditions. The Commands and Reports section of this
manual gives a description of the command.
NOTE:
The Active Alarm and Status Report is output automatically
following CIT log in. The report shown in Figure 1 is an example that
shows several entries. There may be only one entry in the actual report.
Note the information in the Source Address and Description columns for
the top entry/entries above the first single-dashed line in the Active Alarm
and Status Report (Figure1)(forexample,
abnormal a-1-1 MM-DD HH:MM:SS nsa DS1 loopback).
Figure 1 – Example of Active Alarms and Status Report
/* Active Alarms and Status Report
=============================================================
Alarm Source Date Time Srv Description
Level Address Detected
=============================================================
abnormal a-1-1 MM-DD HH:MM:SS nsa DS1 loopback
-------------------------------------------------------------
*/
DLP-521
To Next Page
Loading...
Need help?
General
