DLP-525: Detailed Level Procedure 363-206-285
Page 7 of 10 Issue 2, February 2000
DDM-2000 OC-3 MULTIPLEXER
18. Enter the command ins-prog:tid
Where tid = the target identifier (shelf name) for the DDM-2000
shelf having the new program installed.
Response: /*\ Testing For IMA LAN Program
Installation...\ */
After several seconds, the PC prints a Caution!
message followed by the prompt:
Execute? y/n =.
19. Was response correct?
If YES, then continue with Step 20.
If NO, then do Trouble Clearing: TAP-122.
20. Enter a y or yes and a carriage return to execute the program. Software
download may take up to 5 minutes.
Response: ABN and NE ACTY LEDs light on User Panel, and a P is
displayed in SYSCTL FE ID display in the shelf receiving
the program. PC starts download and prints the following
message:
Searching for optimal transfer rate.
Handshake established at <baudrate> baud.
In progress....
The dots continue to print until program installation is
complete. If floppy disks are being used, insert each
diskette when prompted. After installation is completed,
the PC prints the following completion message:
ins-prog:TID COMPLD
/* IMA LAN Generic program a.b.c is
installed */
The SYSCTL resets and the LEDs go off on the User
Panel and the SYSCTL.
21. Was response correct?
If YES, then continue with Step 22.
If NO, then do Trouble Clearing: TAP-122.
TAP-122
To Next Page
Loading...
Need help?
General
