DLP-552: Detailed Level Procedure 363-206-285
Page 1 of 4 Issue 2, February 2000
DDM-2000 OC-3 MULTIPLEXER
Install/Remove Lightguide Buildout
1.
!
WARNING:
Unterminated optical connectors may emit invisible laser radiation. Avoid
direct exposure to the beam. Do not view beam with optical instruments.
Use of controls or adjustments or performance of procedures other than
those specified herein may result in hazardous radiation exposure.
!
CAUTION:
Use static ground wrist strap whenever handling circuit packs or working
on DDM-2000 terminal to prevent electrostatic discharge damage to
sensitive components.
Is buildout being installed or removed?
If Installing, then continue with Step 2.
If Removing, then continue with Step 5.
2. Remove protector caps and plugs (if equipped) from buildout and buildout
block.
3. Align lightguide buildout locking tab with slot in buildout block (unlocked
position), push in, and rotate clockwise until locked into position. Refer to the
appropriate figure for the specific buildout type.
4. STOP! YOU HAVE COMPLETED THIS PROCEDURE.
To Next Page
Loading...
Need help?
General
