363-206-285 Detailed Level Procedure: DLP-558
Issue 2, February 2000 Page 1 of 8
DDM-2000 OC-3 MULTIPLEXER
Make VT1.5 (DS1) or STS1 Cross-Connections Using
CIT Stand Alone OC3/OC1 Ring Configuration
1.
NOTE:
This procedure may also be found in the DDM-2000 FiberReach
User/Service Manual, Volume 2.
NOTE:
If you are not familiar with doing cross-connections using the CIT
commands, it is strongly suggested that you read Cross-Connection
Provisioning in the Administration and Provisioning section in Volume 1 of
this manual. Also, read the description of the following commands in the
Commands and Reports section of this manual: ent-crs-vt1,
rtrv-crs-vt1,anddlt-crs-vt1.
NOTE:
You will have to login to more than one node in each ring to get a
complete map of the network using the rtrv-map-network: and
rtrv-map-neighbor: command. If a drawing of the network is not
provided with the work order, it is recommended that you draw a simple
schematic of the network before making cross-connections.
Make a simple drawing of the network and list the TID of each node and
how they are connected to each other. Figure 1 shows an example of a
simple schematic.
To Next Page
Loading...
Need help?
General
