363-206-285
Maintenance Description
9-52 Issue 3 June 2001
DS3 Parameters 9
Performance Monitoring Enabling 9
Collection of DS3 path parameters are initiated when a slot is equipped with a
DS3 circuit pack, the port is in the IS or NMON state, the DS3 port is provisioned
for P-Bit violation monitoring (VM mode) or P-Bit violation monitoring and removal
(VMR mode), and a default or manual STS-1 cross-connection is present.
Parameters continue to be available in reports and generate appropriate TCAs
until the input signal to the DS3 interface is removed and the update command
or the UPD/INIT button is pressed (transitioning to the AUTO state). Alternatively,
the DS3 path parameter can be disabled by setting the DS3 port to the clear
channel mode (CC) using the set-t3 command. The PM mode parameter
should be set to "on" (default) using the set-t3 command to start PM data
monitoring and reporting.
For the TMUX circuit pack, DS3 PM is always enabled if the DS3 port is in the IS
state.
To Next Page
Loading...
Need help?
General
