Issue 2 February 2000
11-1
11
Commands and Reports
11
Overview
11
This chapter describes the command and report features of the American
Standard Code for Information Interchange (ASCII) terminal interface to a DDM-
2000 OC-3 Multiplexer. It provides detailed information about each command, as
well as system report outputs and explanations.
Reason for Ressue
11
This chapter has been updated toprovide the details of software commands for
OC-3 Release 15. This release features Target ID Address Resolution Protocol
(TARP) which provides for multi-vendor interworking. For additional information on
TARP, please refer to the “About This Document” sections.
The following new commands are available in OC-3 Release 15:
—rtrv-lan
— rtrv-pm-lan
—set-lan
Please note that the 29G-U OLIU circuit pack must be present in the Main slots of
the DDM-2000 OC-3 shelves for these new commands to properly execute.
Please refer to the TOP section of this document for instructions on properly
installing these circuit packs in a shelf.
Command Page Format
11
This chapter includes DDM-2000 commands that are presented as one- or
multiple-page entires in alphabetical order. The name of each command appears
at the top of each page.
To Next Page
Loading...
Need help?
General
