Lucent Technologies DDM-2000 OC-3 User Manual

APPLY APPLY
DDM-2000 OC-3 Issue 3 June 2001 11-25
If the user issues an apply command for IMA LAN software generic, but the dormant
area contains NE software generic, the following denial message is displayed:
The above denial also applies to the opposite case (the user issues an apply command
for NE software, but the dormant area contains IMA LAN software) as well.
If an apply command is issued to schedule (install or NULL) a software installation but
time is entered with invalid syntax, the user will be reprompted to enter a valid time
value.
If an apply command is issued to schedule (install or NULL) a software installation but
date is entered with invalid syntax, the user will be reprompted to enter a valid date
value.
If the time specified is unknown to the local system, the following denial message will be
displayed:
If the date specified is unknown to the local system, the following denial message will be
displayed:
SROF
/* Status, Requested Operation Failed */
/* Mismatch between Dormant SW and requested operation. */
IDNV
/* Input Data Not Valid */
/* Unknown time specified. */
IDNV
/* Input Data Not Valid */
/* Unknown date specified. */
Page 5 of 13

Lucent Technologies DDM-2000 OC-3 Specifications

General

Brand	Lucent Technologies
Model	DDM-2000 OC-3
Category	Multiplexer
Language	English