EasyManua.ls Logo

Lucent Technologies DDM-2000 OC-3

Lucent Technologies DDM-2000 OC-3
2536 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
363-206-285
System Introduction
1-10 Issue 3 June 2001
New controllers. The new BBG8/BBG8B and BBG9 controller circuit
packs provide expanded memory and processing capacity needed
to support large networks. Feature enhancements available with the
new controllers include:
Remote software download. Software can be downloaded
from a PC connected to a DDM-2000/
SLC
-2000 NE to either
the local or remote DDM-2000/
SLC
-2000 NE.
Electronic provisioning. Provisionable parameters are set by
software, thus decreasing the need for DIP switches. CIT
baud rate is provisioned automatically via autobaud
detection.
User-assigned RT miscellaneous discretes increased from
15 to 21.
Upgrades to the new controllers can be done in service.
Enhanced PM. Enhancements to DS1 and DS3 line and path PM to
further support tariff verification. Enhanced DS3 PM requires the
new BBG4B DS3 circuit pack.
Enhanced security. General and reports-only users increased from
50 to 100. Lockout of nonpriviliged users and log of all login
attempts is provided.
Electrical facility loopbacks. DS1, DS3, and EC-1 equipment
loopbacks of the incoming low-speed signal back towards the DSX.
STS path trace. Provided in the J1 byte of the SONET path
overhead to verify STS path continuity. Allows "labeling" of STS-1s
and retrieval of the path by the "label." For example, "ABC #1." STS
path trace requires the new BBG4B DS3 circuit pack.
Provisionable AIS or unequipped conditions. Path AIS provisionable
on a path basis. Provides user provisionable generation of AIS or
path unequipped signal on a per-shelf basis. Useful in managing
cross-connection provisioning if cross-connections are inadvertently
deleted.
Provisionable line and path AIS alarm levels. Alarm levels can be
provisioned on a per-line or per-path basis.
Brownout protection. If the voltage to the shelf drops below the safe
operating voltage, the system will suspend normal operations and
wait for safe operating voltage to return. Assuming a sufficient
voltage level, an "L" will be displayed on the system controller
(SYSCTL).

Table of Contents

Other manuals for Lucent Technologies DDM-2000 OC-3

Related product manuals