OPR-LPBK-T3 OPR-LPBK-T3
DDM-2000 OC-3 Issue 3 June 2001 11-153
If the command cannot be completed due to hardware problems on the circuit pack, the
following message is displayed:
Address
and
CPname
refer to the slot address and provisioned circuit pack type for the
slot, respectively.
If a slot is in AUTO state or is determined to have the wrong circuit pack type for the
command, the following message is displayed:
If the command cannot be completed due to hardware problems on the SYSCTL, the
following message is displayed:
If it is determined that a slot has the wrong pack type for the command, one of the
following messages will be printed on the CIT:
Where
address
is a slot AID:
/*
Address CPname
CP failed */
/*
Slot
is in AUTO state or
Address
is not equipped - no
loopback established */
/* Enter DS3 port Address: */
/* SYSCTL failed - no loopback established */
/*
address
is not equipped for DS3 */
/* Enter DS3 port address: all, {a, b, c}-{1,2,all} */
/*
address
not properly equipped */
/* Enter DS3 port address: all, {a, b, c}, {a, b, c}-{1,2,all} */
Page 3 of 5
To Next Page
Loading...
Need help?
General
