Maeda CC1908S-1 - Page 226

6.8 FUSIBLE LINKS M A E D A Crawler Crane
6-18 5/2020 CC1908S-1
[1] Fusible link 1
The fusible link 1 is located on the left hand side
inside the battery compartment.
[Fusible link capacity and circuit names]
No. Fuse No. Capacit
y
Connected to
(1) FL1 65A
Permanent power
supply
(2) FL2 65A
BR power supply
(revolving)
(3) FL3 65A
BR power supply
(floor)
* The BR power supply is fed when the starter
switch is turned on.
If any of the following phenomena occur, a fusible
link may have blown. Inspect and replace the
fusible link.
• If power is not supplied to the fuse box 1
permanent power supply, fusible link FL1 (1)
may have blown.
• If power is not supplied to the fuse box 1 BR
power supply, fusible link FL2 (2) may have
blown.
• If power is not supplied to the fuse box 2 BR
power supply, fusible link FL3 (3) may have
blown.
[2] Fusible link 2
The fusible link 2 is located inside the frame with
the post cover (2) removed.
 The top cover on the hydraulic oil tank (1)
must be removed in order to remove the post
cover (2).
[Fusible link capacity and circuit names]
No. Fuse No. Capacit
y
Connected to
(4)
EFL1 80A Glow
(5)
EFL2 60A Starter
If any of the following phenomena occur, a fusible
link may have blown. Inspect and replace the
fusible link.
• If the AUTO GLOW lamp does not turn on even
when the starter switch is turned to the "ON"
position, and the engine is difficult to start in
cold conditions, the fusible link EFL1 (4) may
have blown.
• If the starter does not operate when the starter
switch is turned to the "START" position, the
fusible link EFL2 (5) may have blown.