Crane operation
11.7 Heating and air-conditioning system
Operating Manual GMK6300L 3 112 xxx en 11 - 139
xx.xx.xxxx
• To retrieve a storage location, press the button (1) once.
The following flash:
– The retrieved storage location, e. g. 2
– The last saved heating start, e.g. 06:00.
• Set the time for the desired heating start – button (1) or (2), e.g. 08:00.
Wait for approx. 5 seconds until the weekday for the heating start flashes,
e.g. MO for Monday.
• Set the weekday for the desired heating start – button (1) or (2).
Wait for approx. 5 seconds until the current time is displayed, e. g. 14.00.
Now, the new heating start has been saved and switched on.
H
If you wish to store one or two more heating starts, retrieve a new storage
location using the button (1) and repeat the procedure.
After you have saved the heating start, you can also set the heating period;
à p. 11 - 139.
Setting the heat-
ing period
After an automatic start, the heating system will switch off automatically as
soon as the set heating period has elapsed.
The heating period applies to all saved heating starts.
• Switch off the heating system using the button (1).
• Press the button (2) for longer than 3 seconds.
s
To Next Page
Loading...
Need help?
General
