Malfunctions during crane operation
14.5 Emergency operations and programs
Operating Manual GMK6300L 3 112 xxx en 14 - 47
xx.xx.xxxx
Checks – Before telescoping
• Externally inspect the truck crane to check that the swing-away lattice is
in the telescoping position.
– Before on-road driving
• Externally inspect the truck crane to check that the swing-away lattice is
in the rigging position.
Starting the
emergency
program
Only start the emergency program when the symbol (1)
is displayed;
à Telescoping mechanism error messages, p. 14 - 19.
• Press the right dead man's switch (3).
• Also press button (2) once – symbol (4)
appears.
• Press the buttons (1) in the following order:
Æ
Ã…
Æ
Ç
The symbols (5) confirm the entry.
If your input was incorrect, all symbols (5) go
out and you need to re-enter.
You can cancel the entry at any time using
button (6).
When input is correct, the symbol (1) is displayed – the
Telescoping
emergency programme starts.
s
G
Risk of accidents by exceeding the permissible vehicle width!
Always bring the swing-away lattice to the on-road driving position before
driving on public roads. In this way you can prevent putting other road
users at risk and causing accidents.
To Next Page
Loading...
Need help?
General
