Microplex LOGIJET TC8 - Hexdump Mode Activation

Panel Functions 117
_________________________________________________________________________________________
_________________________________________________________________________________________
Microplex logiJET TC8 Edition 1.2
7.11. Hexdump Mode Activation
Within the Hexdump Mode the printer prints all characters received
via interface without any interpretation (hexadecimal coded).
This mode helps with error diagnosis. The Hexdump Mode can be
activated only temporarily.
Panel display
[ON LINE ]
[Menu Level 1 ]
[Status Sheet ]
  
[Hexdump ]
[Hexdump ]
Notes
Turn the printer OFF LINE with this
key.
Menu level 1 is selected.
Press the NEXT or PREVIOUS key
until [Hexdump ] is displayed.
The Hexdump Mode is activated.
Turn the printer ON LINE again:
Press the ONLINE key longer than
2 seconds.
Note:
By activating the normal print mode (see next section) or by
turning the printer off and on again the printer can be taken out of
Hexdump Mode.
Time between turning the printer off and on again should be at least
15 seconds.