Microplex LOGIJET TC8 - Data Interface Configuration

122 Panel Functions
_________________________________________________________________________________________
_________________________________________________________________________________________
Microplex logiJET TC8 Edition 1.2
7.16. Data Interface Configuration
This function is used to set the interface parameters.
Panel display
[ON LINE ]
[Menu Level 1 ]
  
[Configuration ]
[Interface ]
[SIA Timeout ]
[ 30 s ]
  
[ 40 s ]
[Save as Setup? ]
Notes
Turn the printer OFF LINE with this key.
Press the NEXT or PREVIOUS key until
[Configuration ] is displayed.
Press the ENTER key to change the
timeout.
The currently set value for he timeout is
displayed (here: 30 seconds).
Pressing the NEXT or PREVIOUS key
changes the timeout.
The timeout (the waiting period for SIA to
switch to the next interface) is increased
to 40 seconds.
In addition this new value can be saved as
setup value (using the ENTER key).
After this decision turn the printer ON
LINE again: Press the ON LINE key
longer than 2 seconds.
Note:
The printer uses SIA (Simultaneous Interface Administration) to
check, which interface is currently used for the transfer of print data.