Microplex LOGIJET TC8 - Emulation Selection

Panel Functions 123
_________________________________________________________________________________________
_________________________________________________________________________________________
Microplex logiJET TC8 Edition 1.2
7.17. Emulation Selection
With this function you can change the active emulation.
Panel display
[ON LINE ]
[Menu Level 1 ]
  
[Configuration ]
[Interface ]
  
[Emulation ]
[SOLID Standard ]
  
[HP PCL 5 ]
[Save as Setup? ]
Notes
Turn the printer OFF LINE with this
key.
Press the NEXT or PREVIOUS key
until [Configuration ] is displayed.
Press the NEXT or PREVIOUS key
until [Emulation ] is displayed.
Press the NEXT or PREVIOUS key
until the desired emulation (e.g. HP
PCL 5) is displayed.
The emulation HP PCL 5 is selected.
In addition this new value can be
saved as setup value (using the
ENTER key).
After this decision turn the printer
ON LINE again: Press the ON LINE
key longer than 2 seconds.