Microplex LOGIJET TC8 - Image Shifting to the Y-Direction

138 Panel Functions
_________________________________________________________________________________________
_________________________________________________________________________________________
Microplex logiJET TC8 Edition 1.2
7.28. Image Shifting to the Y-Direction
This function shifts the print image (both colors together) in
relation to the paper to the Y-direction (print direction).
Panel display
[ON LINE ]
[Menu Level 1 ]
  
[Engine ]
[Printspeed ]
  
[Image Y-Pos. ]
[Y-Pos.: 0 Dot ]
  
[Y-Pos.: +120 Dot ]
[Save as Setup? ]
Notes
Turn the printer OFF LINE with this
key.
Press the NEXT or PREVIOUS key until
[Engine ] is displayed.
Press the NEXT or PREVIOUS key until
[Image Y-Pos.] is displayed.
The panel function Image Shifting to
the Y-Direction is selected.
Currently set value (0 =Default).
Operating the NEXT or PREVIOUS key
the image can be shifted relative to
the paper. Values from -496 up to
+496 Dot are settable, so a max. image
shifting of approx. ± 1.6 Inch (approx. ±
42 mm) can be reached.
Now the new image Y-Position is
saved.
In addition this new value can be saved
as setup value (using the ENTER key).
After this decision turn the printer ON
LINE again: Press the ON LINE key
longer than 2 seconds.