Microplex LOGIJET TC8 - Generating Test Prints (Sliding Pattern)

Panel Functions 121
_________________________________________________________________________________________
_________________________________________________________________________________________
Microplex logiJET TC8 Edition 1.2
7.15. Generating Test Prints (Sliding Pattern)
This function generates a series of test prints without sending
data to the printer.
These test prints facilitate error analysis.
Panel display
[ON LINE ]
[Menu Level 1 ]
[Status Sheet ]
  
[Sliding Pattern ]
[Sliding Pattern ]
Notes
Turn the printer OFF LINE with this
key.
Menu level 1 is selected.
Press the NEXT or PREVIOUS key
until [Sliding Pattern ] is displayed.
A series of test prints is generated.
Turn the printer ON LINE again:
Press the ONLINE key longer than
2 seconds.

The printing out of test prints can be stopped by pushing the
ESC key.