Microplex LOGIJET TC8 - Selecting the Tear off Mode (Option: Cutting Mode)

142 Panel Functions
_________________________________________________________________________________________
_________________________________________________________________________________________
Microplex logiJET TC8 Edition 1.2
7.30. Selecting the Tear Off Mode (Option: Cutting Mode)
the following media processing.
Panel display
[ON LINE ]
[Menu Level 1 ]
  
[Engine ]
[Printspeed ]
  
[TearOff Menu ]
[TearOff Mode ]
[OFF ]
  
[ON ]
[Save as Setup? ]
Notes
Turn the printer OFF LINE with this key.
Press the NEXT or PREVIOUS key until
[Engine ] is displayed.
Press the NEXT or PREVIOUS key until
[TearOff Menu ] is displayed.
Press the NEXT or PREVIOUS key until
the desired value is displayed.
The tear off mode is selected.
In addition this new value can be saved as
setup value (using the ENTER key).
After this decision turn the printer ON
LINE again: Press the ON LINE key
longer than 2 seconds.