162 Operator Maintenance
__________________________________________________________________________________________
_________________________________________________________________________________________
Microplex logiJET TC8 Edition 1.2
8.1.4. Cleaning the Sensors
The device is provided with sensors to enable controlling of
consumable movements.
The upper media sensor (Transparent sensor) and the lower media
sensor (Reflex sensor) are both
mounting:
During the print process this two sensors first of all may be soiled
by paper dust. A large amount of dirt is able to cause problems.
Go on like this to remove dust and dirt from the sensors:
1. Switch the printer OFF.
2.
3. Unlock the rear printhead assembly by pushing the printhead
release lever and raise the printhead assembly to a vertical
position.
4. Unlock the transparent sensor guide by pushing its lever and
raise the transparent sensor guide until it stops (as shown in
figure 8.1.4.a+b).
To Next Page
Loading...
