Microplex LOGIJET TC8 - Selection of Memory Distribution (Input Buffer)

Panel Functions 127
_________________________________________________________________________________________
_________________________________________________________________________________________
Microplex logiJET TC8 Edition 1.2
7.20. Selection of Memory Distribution (Input Buffer)
This function enables the user to choose the distribution of the
available RAM memory between input buffer and macro/download
memory.
Panel display
[ON LINE ]
[Menu Level 1 ]
  
[Configuration ]
[Interface ]
  
[Input Buffer ]
[32 kB ]
  
[100 kB ]
[Save as Setup? ]
Notes
Turn the printer OFF LINE with this key.
Press the NEXT or PREVIOUS key until
[Configuration ] is displayed.
Press the NEXT or PREVIOUS key until
[Input Buffer ] is displayed.
Press the NEXT or PREVIOUS key until
the desired memory distribution is
displayed. The input buffer size is
specified in kilobyte (kB) or in percent of
the installed memory.
100 kB is selected as input buffer.
In addition this new value can be saved as
setup value (using the ENTER key).
After this decision turn the printer ON
LINE again: Press the ON LINE key
longer than 2 seconds.