Microplex LOGIJET TC8 - 4 Basic Operation Sequences; Overview

Basic Operation Sequences 23
_________________________________________________________________________________________
_________________________________________________________________________________________
Microplex logiJET TC8 Edition 1.2
4. Basic Operation Sequences
4.1. Overview
ribbon loading
media loading
label
page length /paper width setting
margin setting
see chapter 5
see chapter 5
see chapter 7
see chapter 7
start
printhead pressure adjusting *
see chapter 5
Adjustment of the Red Image (X/Y -Offset)
adjusting the zero position of the material transport *
(Sync.Sens.Offset)
see chapter 7
Sync sensor adjusting *
slip correction adjusting *
see chapter 7
see chapter 7
see chapter 7
adjusting the printer to the paper type *
*
Black Mark
lower+upper sensor (Gap)
lower sensor (Reflex)
continuous
*) A calibration must be performed when media and ribbon are first installed in
the printer, or when different type of media or ribbon is being used.