Microplex LOGIJET TC8 - Page 178

178 Troubleshooting
_________________________________________________________________________________________
_________________________________________________________________________________________
Microplex logiJET TC8 Edition 1.2
Defect
Remedies
Printout blurred or
incomplete
- clean both printheads
(see section 8.1.2)
- check the ribbon transport of both print units
(load the ribbon again, if necessary;
see section 5.2)
- also, see section 9.3: Incorrect Media Transport
- the printheads have to be exchanged if, for
example after a big printout performance the
If the remedies above are not successful, please call a Microplex
authorized service engineer.