MIMAKI JV3-160SP User Manual

– 5.27 –
5-3-13. SET QUALITY
[Function]
Sets the operation mode of the user-defined PRINT MODE-QUALITY.The setting values
are stored under the systeme parameters No. 46 to 51.
The settting value is issued in the maintenance list at the time of maintenance release.
[Operation]
1) Select the “ADJUSTMENT” .
Press the
ENTER
key.
2) Select the “SET QUALITY” pressing the
FUNCTION
key.
Press the
ENTER
key.
3) Select the resolution using the
or
key, and then press the
ENTER
key.
DPI: 360 x 360, 360 x 540, 360 x 720, 720 x 720,
720 x 1440, 1440 x 1440
4) Select the quality using the
or key,
and then press the
ENTER
key.
QUALITY: Standard, Fine, Highspeed
5) Select the number of divisions using the
or key, and then press the
ENTER
key.
PASS: 1pass, 2pass, 3pass, 4pass, 6pass, 8pass,
12pass, 16pass, 32pass
• Some items cannot be selected and
other combinations may apply
depending on the ink set (4 colors,
6 colors) or the resolution.
6) Select the high-speed scan (on/off) using the
or key, and then press the
ENTER
key.
• Some items cannot be selected
depending on the resolution and the
number of divisions.
7) Press the
ENTER
key to exit from the
function.
FUNCTION
# ADJUST < ENT >
# ADJUST
SET QUALITY < ent >
# SET QUALITY
DPI : 360 X 360
# SET QUALITY
QUALITY : STD
# SET QUALITY
PASS : 2pass
# SET QUALITY
High SPEED : ON

MIMAKI JV3-160SP Specifications

General

Brand	MIMAKI
Model	JV3-160SP
Category	Plotter
Language	English